CAN Module
Top View
Bottom View
Schematics can be found here.
- Module ID: 3
- Fully isolated power and signals
- Outputs can be disconnected with a relay
- Termination resistor can be connected with a SSR relay
- IN_A: nc
- IN_B: nc
- IN_C: SWITCH - a HIGH signal switches the output relay ON and connects the outputs to the connector
- IN_D: ID - Used to set the module ID
- IN_E: nc
- IN_F: TERMINATION - a HIGH signal enables the termination resistor between CAN High and CAN Low
- IN_G: CAN_TX - Non-isolated TX pin for the CAN transceiver
- IN_H: CAN_RX - Non-isolated RX pin for the CAN transceiver
- OUT_A: 5V isolated
- OUT_B: GND isolated
- OUT_C: CAN High (CAN +)
- OUT_D: CAN Low (CAN -)
- CAN
The board is 4 layer, 23.5x28 mm.
Mechanical Drawing