01 Shopping List
In order to set up one MCU instance, you will need the following:
-
1 Raspberry Pi 3 (Note, the software should work on any version of Raspberry Pi but has only been tested on Raspberry Pi V3)
-
1 Raspberry Pi power supply
-
1 micro SD card, 4 gigabytes or larger and a micro SD card adapter.
-
1 ethernet cable
-
Access to a router with available ethernet ports (or connect via wifi (not covered in this wiki))
-
A hardware device that you want to control and any associated components. (i.e. A 3D printer, 3D printer power supply, a USB cable to connect a printer's firmware board to the Raspberry Pi)