Block Selection
Block selection in vy is done in the NORMAL mode, there is no mode for block selection. In this way, it is possible to perform some interesting operations quickly.
Block selection works with a mark as range selection does. In order to drop a block selection mark, switch to NORMAL mode then press:
<Control-V>
It will appear a msg on the statusbar saying that a block selection mark was dropped at the cursor position.
Once a block selection mark was dropped, press the keycommand below in NORMAL mode to add/remove block selection one line up:
<Control-K>
Switch to NORMAL mode then press:
<Control-J>
You need to have first dropped a block selection mark.
This command works as well in NORMAL mode, supposing you have dropped a block selection mark.
Press:
<Control-H>
Make sure you have dropped a block selection mark then press:
<Control-L>