Pro Trinket SNES Gamepad

Sketch for Adafruit's Pro Trinket that reads in the input from an SNES controller and outputs gamepad over USB.

Usage

This code is designed for Adafruit's Pro Trinket 5V. Instructions for setting up the Pro Trinket in the Arduino IDE can be found here. For the Pro Trinket, set the board to Adafruit Pro Trinket 16MHz(USB) and the programmer to USBtinyISP in the Arduino IDE. Learn more about about the Pro Trinket here.

Hardware

Pin setting

SNES	Pro Trinket
White(Vcc)	5V
Orange(Latch)	GPIO 3
Red(Clock)	GPIO 5
Yellow(Data)	GPIO 6
LED(on board)	GPIO 13
LED(function mode status)	GPIO 9
Button(for function mode)	GPIO 10

Software

The Pro Trinket can then be programmed and connected to the computer using a USB cable.

Using library

buxit/Pro_Trinket_USB_Gamepad

inspired by...

Thanks to zfergus/trinket-snes-controller

ToDo

• Function mode implementation.

License

MIT.