This project contains the code and data for Phase-Functioned Neural Networks for Character Control as presented at SIGGRAPH 2017, with the project page found below:
http://theorangeduck.com/page/phase-functioned-neural-networks-character-control
This paper presents a character controller driven by a special kind of network called a Phase-Functioned Neural Network which learns a mapping from the user input parameters, the character's previous state, and the surrounding environment to the pose of the character at a given frame. The rest of this README will assume you have read the paper and understand the basic workings and processes involved in this technique.
The code is essentially separated into two sub-projects.
The first project is a set of python scripts written in Numpy/Scipy/Theano which preprocess the motion data, generate a database, and train the phase functioned neural network to perform the regression. The output of this project are the network weights saved as simple binary files.
The second project (contained in the subfolder "demo") is a C++ project which contains a basic runtime that loads the network weights and runs an interactive demo which shows the results of the trained network when controlled via a game-pad.
Below are details of the steps required for reproducing the results from the paper from preprocessing and training all the way to runnning the demo.
Before you do anything else you will first need to install the following python
packages numpy, scipy, Pillow, theano as well as CUDA, cuDNN etc.
This project was built using Python3 but may work with Python2 given a few
minor tweaks.
The next step is to build the database of terrain patches which are later fitted to the motion. For this simply run the following.
python generate_patches.py
This will sample thousands of patches from the heightmaps found in
data/heightmaps and store them in a database called patches.npz. This
should take a good few minutes so be patient.
Now you can begin the process of preprocessing the animation data - converting it into the correct format and fitting the terrain to each walk cycle. For this you run the following:
python generate_database.py
This process can take some time - at least a couple of hours. It uses all the
data found in data/animations and once complete will output a database called
database.npz. If you want to change the parameterisation used by the network
this is probably the place to look - but note that the preprocessing for this
work is quite fiddily and complicated so you must be careful when you edit this
script not to introduce any bugs. You will also have to remember to update the
runtime to match.
Once you've generated database.npz you can begin training. For this simply
run the following:
python train_pfnn.py
Assuming you've installed theano, CUDA, and everything else successfully
this should start training the neural network. This requires quite a lot of RAM
as well as VRAM. If you get any kind of memory error you can perhaps try using
less data by subsampling the database or even taking some of the clips out of
the preprocessing stage by removing them from generate_database.py.
During the training process the weights of the network will be saved at each
epoch to the location demo/network/pfnn so don't worry about stopping the
training early. It is possible to achieve decent results in just an hour or so
of training, but for the very best results you may need to wait overnight. For
this reason it might be worth making a backup of the pre-trained demo weights
in demo/network/pfnn before beginning training.
With the network weights generated you're now ready to try the runtime. For
instructions for this please look inside the demo folder.