DblTIme2 - display two timezones
NOTE: to allow full use of the buttons, DblTime2 loads in as an app (at the same menu level as "Settings" on the Pebble), not as a watchface . . . it just displays a watchface
Features (v 2.2):
- dual date & time displays
- with black-on-white for daytime displays & white on black for nighttime displays
- adjustable # hours offset (-23:30 to +23:30) in 30-minute increments, between primary & secondary time displays (default = 0:00)
- when # hours offset = 0, secondary date & time are not displayed (primary time display only)
- enable/disable snooze mode (display blanks after 10 seconds) - default = enable
- enable/disable hourly chime mode (buzzes on the hour & activates display) - default = disable
- selectable mm/dd/yy vs dd/mm/yy date display - default = mm/dd/yy
- enable/disable display of seconds - default = enable
- displays 12/24 hour format time (using current Pebble Settings)
- minimal delay when showing time at start-up & when waking from snooze
- preference settings saved in persistent storage
Operating instructions:
- to enter "set mode" (snooze), long-press the "select" (middle) button (Z's blink)
- with "set mode" on "snooze", press the "up" & "down" buttons to toggle between "enable" & "disable"
- to change "set mode" to "chime", long-press the "select" button (bell blinks)
- with "set mode" on "chime", press the "up" & "down" buttons to toggle between "enable" & "disable"
- to change "set mode" to "month-day", long-press the "select" button (M/D blinks)
- with "set mode" on "month-day", press the "up" & "down" buttons to toggle between mm/dd/yy & dd/mm/yy
- to change "set mode" to "display seconds", long-press the "select" button (S blinks)
- with "set mode" on "display seconds", press the "up" & "down" buttons to toggle between "enable" & "disable"
- to change "set mode" to "offset", long-press the "select" button (TZ blinks)
- with "set mode" on "offset", press the "up" & "down" buttons to adjust the offset value by 30-minute increments
- with "set mode" on "offset", press the "select" button to force the offset back to 0
- to exit "set mode", long-press the "select" button (nothing blinking)
- with "snooze" mode activated (display blank), press the "up" or "down" buttons to repaint the display
Mark J Culross (KD5RXT) mjculross@sbcglobal.net