An A10 Thunder to Fluentd proxy server
This program/Docker Container will take in the logging output from an A10 Thunder device, and "push" it over to a fluentd server.
You can either just run the fluentproxy.js program, or build a Docker container. Either way, you will need to create a config.json file in order to configure the program.
The config.json file looks like this:
{
"debug": 0,
"showstart": true,
"label": "a10",
"port": 5514,
"timeout": 3.0,
"reconnect": 60000,
"fluent_ip": "172.17.0.3",
"fluent_port": 24224
}
debug is a value (0 - 10) to set for debugging information to be printed out. Anything above a '7' is pretty verbose.
showstart is a boolean that prints out and pushes to fluentd a message about the a10-fluent starting.
label is the label used for the records pushed to fluentd. In this example, they would show up as debug.a10
port is the local port to listen to for log messages from the A10 Thunder device(s).
timeout is the timeout value for connecting to the defined fluentd node. It defaults to 3 seconds.
reconnect is how long the program waits to try and reconnect to fluentd. it defaults to 60 seconds.
fluent_ip is the IP address or FQDN of the fluentd node. It defaults to 0.0.0.0
fluent_port is the IP Port to use when connecting to the fluentd node. It defaults to 24224
There are two lines you need to add to the Thunder configuration:
!
logging syslog information
!
! logging host {IP of node/container running the program} use-mgmt-port port {port}
logging host 172.17.0.16 use-mgmt-port port 5514
!
The {port} value needs to be the same value from the port: line of your config.json file. The use-mgmt-port parameter is optional. Use it if your a10-fluent program is running on the same subnet or network that the A10 Thunder device has its Management port connected to. Otherwise it will try and connect using a Data Port.
This will stop logging on the Thunder in favor of logging on the a10-fluent/fluentd solution.
The build_container.sh file has an example of how to create the a10-fluent Docker container.
docker run -d --restart=always \
--name=a10fluent \
-p 5514:5514 \
-p 5514:5514/udp \
-v $(pwd)/config.json:/proxy/config.json \
a10networks/a10-fluent:latest
Keep in mind that the port commands need to match what you have in your config.json file for the ''port'' option.