This repo contains a framework for building RC Cars based on Arduino and ESP Wemos board. It contains only the designs and parts you want to 3d-print.
You can also find the project on Thingiverse: https://www.thingiverse.com/thing:3301216
Requires the following parts:
- 2x MotorMounting_Bridge2_length100_4scewHoles.stl
- 1x simpleBaseFrame.stl
- few screws
- 4x tt-motor
- 4x wheels
- controller
- driver board
- remote control
Requires the following parts:
- 2x MotorMounting_Bridge2_length100_4scewHoles.stl
- 1x frameForPickupBodyV1.1.stl
- 1x King_URSA_Front_body_piece.stl
- 1x King_URSA_Center_Body_Piece3.stl
- 1x King_URSA_Rear_Body_Piece.stl
- few screws
- 4x tt-motor
- 4x wheels
- controller
- driver board
- remote control
You can also find this project on Thingiverse: https://www.thingiverse.com/thing:3483392
- 1x simpleBaseFrameForSteering.stl
- 1x MotorMounting_Bridge2_length100_4scewHoles.stl
- 1x axle_v3_crossPart.stl
- 1x axle_v3_lowerPart.stl
- 1x axle_v3_upperPart.stl
- 1x ServoSupport_v2.stl
- 2x transverseLink_v3.stl
- 2x transverseLink_v3_lid.stl
- 2x wheelDist_v3_part1.stl
- 2x wheelDist_v3_part2.stl
- few screws
- In addition a few screws M3 and for the servo a few M2 are required.
- 2x TT-motor
- 4x wheels (two for tt-motors and two for the axle)
- controller (Arduino/ESP or similar) - in this case ESP32 Wemos UNO D1 R32
- driver board - in this case Adafruit Motor/Stepper/Servo Shield for Arduino kit
- remote control (in this case there is a webpage on the esp32 which you can use for steering on your smartphone)