Stream Bend Labs 1 & 2 - axis sensor data to Bend Labs Android Demo app and central_ads_eval_kit demo
- This sketch configures an NRF52 based Arduino development board
- to read data from a Bend Labs One or Two Axis Sensor.
- Implements the BLE Peripheral functionality of the Bend Labs
- Eval Kit. Allows to send data to Bend Labs Android Demo App or
- another NRF52 based Arduino development board with central_ads_eval_kit.ino
- Default configuration is for One Axis Sensor. Change the preprocessor definition
- #define DEMO_DEVICE_ONE_AXIS (1) to #define DEMO_DEVICE_ONE_AXIS (0) for
- interfacing with a Two Axis Sensor.
- Copy the folder 'ads_combined_driver' into your Arduino\libraries folder
- Tested Board: Adafruit Feather NRF52840
- Should work with: Adafruit Feather NRF52832 or similar
- NRF52 Based Bluefruit Board
- Tested With Sparkfun Pro nRF52840 Mini it works but you may have to
- change lines 99 & 100 in variant.h to:
- #define PIN_SERIAL1_RX (15)
- #define PIN_SERIAL1_TX (17)
- This demo interfaces with the ads sensor in polled mode.
- SDA - I2C Data
- SCL - I2C Clock
- VCC - 3.3 V
- GND - Ground
- nRST - 5 RESET line is necessary to operate
- nDRDY - Not Used