CANHUBK3 eth0 down, not able to ping

[dirksavage88]

The default state of eth0 is down, When issuing the command ifup eth0 the interface reports 'okay' but does not init. I am unable to ping out from the device.

[PetervdPerk-NXP]

Netman manages the eth0 interface and turns it off automatically through link detection.

What network config does netman show?

[dirksavage88]

Hmm, so the ping works with dhcp when the connected to my router via T1 converter, but not able to ping the NavQ plus with a static IP.

[dirksavage88]

Basically with dhcp it's able to connect and the link goes up, without dhcp and manually creating a net.cfg with static IP settings the link stays down even with 'ifup eth0'

This is the net.cfg settings I am using to try to setup a static IP:

EDIT: I am using 10.0.0.x on the navq, but tried the user guide settings just be sure. I also used netplan on the navq plus and that link is showing up, but not able to ping canhubk3