JONKEY

The JONKEY is a columnar split keyboard created using ergogen.

Project Contents

• Ergogen Config: jonkey.yml
• PCB Design: pcbs/v1/
• 3D Printable case: case/
• QMK Config: qmk_config/

Notes

• The PCB is a single reversible board, flip it over for the right side
• The Pro Micros need to be attached upside down on the left and right side up on the right for the correct pin alignments
• Currently the QMK firmware has the side hardcoded and needs to be complied individually for each side. To switch between compiling the left/right side firmware, uncomment the appropriate line in the config.h (Lines 16/17)
  • There are free pins (D2, D3) that could be used for high/low indication of side