SPI (Serial Peripheral Interface) is a synchronous serial communication protocol widely used for interfacing microcontrollers, sensors, memory devices, and other peripheral components within embedded systems.
The RTL design of SPI has been implemented by using verilog. The architecture is divided into three essential modules: the Master, Slave, and the SPI top-level module that acts as the Register Interface (RIF) unit.
The master device initiates communication by generating clock pulses and selecting the slave device. The communication occurs via four essential lines: MOSI (Master Out Slave In) for data transmission from master to slave, MISO (Master In Slave Out) for data transmission from slave to master, SCK (Serial Clock) for clock synchronization, and CS (Chip Select) for selecting the target slave device.
The transaction involves three distinct bit-streams of data between START and STOP.
This segment of the transaction serves as an instruction for the target device or peripheral, indicating the operation to be executed. The 8-bit value signifies commands such as read, write, specific function triggers, or control instructions tailored to the device's functionalities.
The 24-bit address field specifies the memory location or register within the target device. This extended addressing range (24 bits) allows for addressing various memory locations or registers, providing flexibility for data access or manipulation.
This portion contains a 32-bit value that embodies the actual data payload transmitted or received during the transaction. The data could represent information intended for writing into a designated memory location or the content read from the specified address, carrying crucial information or payload data.