kasa-pressure

Control your Kasa smart lights with a Raspberry Pi

Materials

• Raspberry Pi
• Breadboard
• 330ohm resistor
• Push button
• 3 Jumper wires
• Kasa light bulbs

Setup

1. Prepare the following simple push button circuit with input 3v from the Raspberry Pi, and output to PIN10 (GPIO1)

• Note: When the button is not pressed, the power flows to ground. This keeps the button in a strictly on/off state*

2. Clone this repo
3. Install docker and docker-compose on the Pi
4. Run docker-compose up -d