Particle Filter Implementation in C++

Project Introduction

Your robot has been kidnapped and transported to a new location! Luckily it has a map of this location, a (noisy) GPS estimate of its initial location, and lots of (noisy) sensor and control data.

In this project we implement a 2 dimensional particle filter in C++. The particle filter will be given a map and some initial localization information (analogous to what a GPS would provide). At each time step the filter will also get observation and control data.

A high level view of Particle Filter

The flowchart below should make the working of a Particle Filter a bit clearer.

Running the Code

Once you have this repository on your machine, cd into the repository's root directory and run the following commands from the command line:

> ./clean.sh
> ./build.sh
> ./run.sh

Inputs to the Particle Filter

You can find the inputs to the particle filter in the data directory.

The Map*

map_data.txt includes the position of landmarks (in meters) on an arbitrary Cartesian coordinate system. Each row has three columns

1. x position
2. y position
3. landmark id

• Map data provided by 3D Mapping Solutions GmbH.

Control Data

control_data.txt contains rows of control data. Each row corresponds to the control data for the corresponding time step. The two columns represent

1. vehicle speed (in meters per second)
2. vehicle yaw rate (in radians per second)

Observation Data

The observation directory includes around 2000 files. Each file is numbered according to the timestep in which that observation takes place.

These files contain observation data for all "observable" landmarks. Here observable means the landmark is sufficiently close to the vehicle. Each row in these files corresponds to a single landmark. The two columns represent:

1. x distance to the landmark in meters (right is positive) RELATIVE TO THE VEHICLE.
2. y distance to the landmark in meters (forward is positive) RELATIVE TO THE VEHICLE.

NOTE The vehicle's coordinate system is NOT the map coordinate system. The code will handle this transformation.