Skip to content

Build OP-TEE, U-boot and Linux for RK3229 based devices

Notifications You must be signed in to change notification settings

jhswartz/rk3229

Repository files navigation

Build OP-TEE, U-Boot and Linux for RK3229

Introduction

This documentation details my experiences with building and installing mainline versions of OP-TEE, U-Boot and Linux for systems based on Rockchip's RK3229. The primary focus of my efforts has been, and remains, on the Mecer Xtreme Mini S6, but some minor testing has been performed with a few boards sold under the MXQ brand due to reader request.

If you decide to use any of the information presented here - think for yourself and acknowledge that you, alone, take full responsibility for your own actions.

Documentation

  • Build

  • Full Installation

    This approach does not rely on any software that was shipped by the vendor.

    Installation to onboard flash on devices that feature NAND instead of an eMMC will not work, as neither mainline U-Boot nor mainline Linux have support for the Rockchip NAND controller. For such devices, follow the installation procedure for SD/MMC instead.

  • Partition Replacement

    This approach uses the bootloader and Rockchip partitioning scheme shipped by the vendor. I do not pursue this approach since enjoying success via Full Installation.

    This will not work for devices that have onboard NAND flash instead of an eMMC, as mainline Linux does not have a driver for the Rockchip NAND controller.

Device Findings

  • Mecer Xtreme Mini S6

    Procedure Status Remarks
    U-Boot + Linux Installation (eMMC) OK -
    U-Boot + Linux Installation (SD/MMC) OK -
    Onboard Flash Partition Replacement OK Unresponsive after 30 minutes
  • MXQ 4K / MXQ-Pro 4K

    Procedure Status Remarks
    U-Boot + Linux Installation (eMMC) Not Applicable Device does not have an eMMC
    U-Boot + Linux Installation (SD/MMC) OK -
    Onboard Flash Partition Replacement Pending No kernel driver for Rockchip NAND controller

Hardware Support

  • CPUs

    • All 4 cores brought up via PSCI.
  • Ethernet

    • 10/100Mbps Full Duplex.
  • GPU

    • Hardware rendering via lima. Be sure to use upstream libdrm and mesa master branches respectively.
  • HDMI

    • Works well if the HDMI connector is forced into the enabled state, and an EDID firmware override is used to compensate for problematic EDID responses from the HDMI sink or for DRM issues.
    • Unfortunately, an unhandled IRQ request message is generated by the kernel when the display is powered down but this does not hinder further use.
  • MMC

    • eMMC and SD/MMC cards.
  • USB

    • Host and OTG modes.
  • Wireless

    • RTL8723BS attached via SDIO works using the r8723bs staging driver.

Acknowledgement

Thank you to the following people for their assistance in making this process possible.

  • Heiko Stübner, for answers and recommendations
  • Fabio Bassa, for testing

About

Build OP-TEE, U-boot and Linux for RK3229 based devices

Topics

Resources

Stars

Watchers

Forks

Packages

No packages published

Languages