Feather daughter board for the Adafruit ESP32 and Huzzah (and others), allowing BLE and RTPMIDI via wifi. Still a work in progress, and can provide the framework for anyone to use other Adafruit Feather boards Lots of Biodata information on my website electricityforprogress.com See also the project submission on Hackaday.io
3D Enclosure Model: https://www.tinkercad.com/things/8HZnh0ERNtr-biodata-wifi-snap-enclosure
Menu Modes:
From normal Biodata mode, by pressing the button you will enter into the Menu selection where you can turn the knob to select different menus listed below. When the desired menu color is illuminated click the button and continue to turn the knob to choose a value. Click a final time to select the value and return to Biodata Mode. Selections are saved and reloaded each time you turn on the device. To 'hard reset' press and hold the button while turning on the device, after the light show the White led will display and the factory default settings are applied (Chromatic Scaling, Channel 1, Bluetooth ON, Wifi OFF).
Red - Note Scaling - Entering this mode will illuminate the Red LED, by turning the knob one of the other LEDs will flash indicating a different Note Scaling. Flashing Red = Chromatic, Orange = Minor, Green = Diatonic Minor, Blue = Major, White = Indian
Orange - MIDI Channel - Entering this mode will illuminate the Orange LED, by turning the knob different combinations of the LEDs are used to display the MIDI Channel in 'Binary'. MIDI Channel can be configured between 1-16, each of the 5 LEDs are used to display the MIDI channel chosen where 1 = 1xxxx, 2 = x1xxx, 3 = 11xxx, etc. The MIDI Channel can then be saved by pressing the button. So far, this MIDI selection method has been a big PiTA for users, but it is kinda clever.
Green - Wifi On/Off - This mode turns on and off Wifi, default is off. Control is similar to the Bluetooth mode. If you have uploaded code with your wifi credentials, you can connect to WiFi MIDI
Blue - Bluetooth On/Off - This mode turns on and off Bluetooth, default is ON. The Blue LED will illuminate and either the Red LED (indicating off) or White LED (indicating on) can be selected by turning the knob. Press the button again to save the setting.
White - Battery Level - Entering into this mode will display the battery charge percentage by illuminating the white LED and one of the other colors will flash. Flashing blue = 100%, green = 80%, Yellow = 50%, Green = 30%