__Advertisement __
- TDM-SIM7600CE-M1S - 2G/3G/4G LTE CAT 4 GPS BREAKOUT MODULE
- TDM-A7600C-L1 - 2G/3G/4G LTE CAT 1 BREAKOUT MODULE.
- A7670C-LASS - 2G/3G/4G LTE CAT 1 BREAKOUT MODULE.
This repo will provide you all data for these module! These module can replaces SIM800L module with complete pinout board & power converter, IO level shifter for your design
- General data::
- Supply voltage range on VCC PIN: 4.8V ~ 16V
- Control Via AT Commands
- Operation temperature: -40℃ to +85℃
- Weight: : 5.7 ± 0.2g
- GNSS:GPS/GLONASS/BeiDou
- Frequency:
- LTE-FDD B1/B3/B5/B8
- UMTS/HSDPA/HSPA+ B1/B8
- GSM/GPRS/EDGE 900/1800MHz
- General data::
-
Supply voltage range on VCC PIN: 4.8V ~ 16V
-
Control Via AT Commands
-
Operation temperature: -40℃ to +85℃
-
Weight: : 5.7 ± 0.2g
-
Frequency:
- LTE-FDD B1/B3/B5/B8
- UMTS/HSDPA/HSPA+ B1/B8
- GSM/GPRS/EDGE 900/1800MHz
-
See more our product at www.linhkienthuduc.com
SIM7600CE AT Command Adruino Test
| Name | Description |
|---|---|
| VIN | Input power for module, input range from 4.8-16V, average supply current should be above 1A (at 12V) |
| GND | GND power |
| PEN | Power Enable signal control, default is pull high (active module), pull down by external npn transistor or IO to turn off the module completely |
| RTS | RTS signal for Uart flow control |
| RXD | Uart receive data |
| TXD | Uart transmit dataa |
| CTS | CTS signal for Uart flow control |
| DTR | DTR signal for Uart flow control |
| PCM-OUT | PCM signal |
| PCM-IN | PCM signal |
| PCM-SYNK | PCM signal |
| PCM-CLK | PCM signal |
| ADC2 | ADC2 input signal |
| ADC1 | ADC1 input signal |
| RI | RI signal |
| NET | Net light signal (displayed by LED onboard) |
| FLYMODE | Flymode |
| RESET | Reset pin for sim module |
| POWER KEY | PWR KEY Pin, default pulled down by 0 Ohm (R10), to using it, please remove R10 |
- These pin supported to connect direct with other MCU with higher logic level (example: 3.3V, 5V, 12V..) as below:
| Name | Description |
|---|---|
| 3.3V or 5V logic level | TX, RX, DTR, RTS, CTS, RI |
