Releases · Octal450/IT-AUTOFLIGHT

Changelog:

[Control Loop]

Added: Basic pitch hold mode
Added: Improved pitch flight director computation
Added: Better adjustment for takeoff flight director pitch bar (New config required)
Added: Configurable auto elevator trim bounds (New config required)
Fixed: Minor issue with roll hold mode
Changed: Improved pitch control law for high altitude

[Logic]

Added: Ability to allow modes to be selected on the ground (New config required)
Added: Third autopilot option
Added: Basic pitch hold mode
Added: Throttle mode annunciation property mode/thr
Added: Ability to adjust maximum target knots and mach (New config required)
Added: Ability to define angle of attack where AP trips off (New config required)
Fixed: Ensure route manager errors do not block ITAF loop
Changed: Speed mode text property has changed from mode/thr to mode/spd

[GUI]

Changelog:

[Control Loop]

Added: Internal control drivers for overridable yoke (New config required)
Added: New speed on pitch control loop without integrator
Added: Ability to not drive throttle directly with autothrottle
Added: CWS interrupt ability
Added: More flexible bank limit system with overrides (New config required)
Added: Ability to adjust FLCH acceleration/deceleration rate (New config required)
Added: Improved flight director pitch calculation
Added: Ability to adjust flight director pitch bar when on the ground in takeoff mode
Added: T/O roll mode now includes ability to capture current heading
Changed: Tweaked rate scheme slightly

[Logic]

Provide feedback