New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Switch between RC and MSP drone contrling on flight #22
Comments
@clashpunk, I've been away from inav for a while, so I am not super aware of the bleeding edge, but I know it now has SITL and HITL, maybe they even have a new flight mode more like arducopter where you can enable autonomous control as you want. |
@ricardodeazambuja, what can be done to have a betaflight flight controller accept BOTH the output of the user's transmitter (manual flight) and the on-board computer (e.g. PI) during flight? If the PI unexpectedly freezes or shuts down mid-flight, then the user can take over and likewise via manual remote and likewise if a user loses a signal, the PI will take over. If this is not possible, can the PI boot up in midflight and take over and then give back control to the user and shut down. Or will the drone crash when this is attempted mid-flight? Also, you said once the on-board computer stops sending commands to the FC, the FC will enter into failsafe. What will happen to the drone if it enters failsafe mid-flight? Is it possible to configure this failsafe to switch the receiver from MSP to the default one (one used by the user)? Thank you for your work on this. |
Have a look at this (old) discussion: betaflight/betaflight#8292 |
I have succefully started simpleUI.py on my SpeedyBee f405 FC via USB cable. My question, is it possible to start manual flight using RC controller and then switch for autonomus controlling with Rasberry PI + YASMPy during flight?
The text was updated successfully, but these errors were encountered: