Replies: 1 comment
-
@1N4003 I set mine up at about 11.5 v because the diffuser I'm using has 69% transmission. (TAP Plastics - Frosted Acrylic - P95 matte finish - Lightning White 69%). I expect it will not affect the arduino or sensors since they all are regulated to 5v. It does affect the light source #2 because I dialed it down in order to calibrate. It seems ok - the Dr Meter light meter tracked pretty well. |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Is it possible to run the setup reliably below 12.5V in order to adjust to a diffusor with a transmission higher than 60%? Is there a bottom limit in terms of voltage?
Beta Was this translation helpful? Give feedback.
All reactions