You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Hello,
First of all thank you for developing such a good software for us to use, here are some of the problems I encountered
I want to make a cylindrical foam bullet and the code I use is as follows
neper -T -n 600 -domain "cylinder(2,1)" -reg 1
neper -M n600-id1.tess -dim 2 -rcl 0.6 -meshface "domtype!=2" -nset none -faset none -format msh,inp -o dim2
But the generated unit is a 2D unit. How should I modify it to make it a 3D unit? It will still have the same shape.
Then when I checked the grid I found there were many errors, below is the error picture
Also, I only want to delete one bottom surface of the cylinder, but I don’t want to delete the other circular surface. How to achieve this?
Sorry for asking you so many questions and hope to get your reply
Finally, I would like to express my gratitude to you again
Thanks!
Beta Was this translation helpful? Give feedback.
All reactions