-
-
Notifications
You must be signed in to change notification settings - Fork 178
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Firmware version issue #527
Comments
Did you install TMC drivers by yourself (or got a used printer with modified drivers)? If not, the answer is most likely “no“, factory setup does not come with updated drivers. Anyway you should notice the wrong FW immediately, as the axes will move in the wrong direction. If you flash the non-TMC version, push “home“ and printer moves to all zero without strange noises, everything is fine. If you wanna be 100% sure you can disassemble the printer, look at the board and check which drivers are installed there. |
4MAXP2_v1.5.3.hex will be a suitable file ? Will it be a good file for the first edition of 4Max Pro? I don't see P1 for the first pro version. |
@stklcode please help :) |
Quoting v1.4.0 Changelog:
My guess would be the |
Hi, i have problem choosing correct firmware.
My printer is Anycubic 4Max Pro (not v2.0):
All i know is that i don't have BL-Touch and I have original DWIN / DGUS II display. But i don't know if i have a TMC.
So, how can i check it and choose right firmware?
The text was updated successfully, but these errors were encountered: