You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
My Mega Pro's z-Stepper is really loud when this fw is installed. I can't tell what causes this exactly, but it is this fw for sure. (Before installing it it was silent and after flashing the original fw it is silent again)
You link the TMC flavor of the firmware and compare against “original“... 🤔 Did you actually replaced the stepper drivers? And if yes, which drivers?
Honestly I have no idea how the original FW “sounds“, moved to different FW after 1 or 2 prints years ago, but at least I cannot remember any significant difference. My Mega P with factory drivers runs just fine with the non-TMC flavor.
Bug Description
My Mega Pro's z-Stepper is really loud when this fw is installed. I can't tell what causes this exactly, but it is this fw for sure. (Before installing it it was silent and after flashing the original fw it is silent again)
Steps to Reproduce
Expected behavior: sound silent as before and after
Actual behavior: The steppers sound a lot louder
The text was updated successfully, but these errors were encountered: