You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
After processing finishes, InaSAFE adds its output layers to the QGIS canvas. These layers seems to slow down QGIS a lot, even just clicking somewhere or panning stalls the software and a user needs to wait up to a few minutes. When these layers are removed from the QGIS canvas, all is fine again. Even for small layers with few features this is an issue, and it only happens with the outputs from InaSAFE.
Suggestion:
Permanently save layers as apposed to temp layers
Expected Behaviour
QGIS should not be stalled by these output layers.
Environment
InaSAFE : 5.0.5
QGIS : All versions
OS : Windows/Linux
Data used :
Exposure : Yes
Hazard : Yes
Aggregation : Yes
Extent : ?
Checklist:
Did you try to run it in debug mode ?
Is the data available ?
If yes, where (BTSync, data.inasafe.org, zip) ?
Proposed Solution
The text was updated successfully, but these errors were encountered:
Problem
After processing finishes, InaSAFE adds its output layers to the QGIS canvas. These layers seems to slow down QGIS a lot, even just clicking somewhere or panning stalls the software and a user needs to wait up to a few minutes. When these layers are removed from the QGIS canvas, all is fine again. Even for small layers with few features this is an issue, and it only happens with the outputs from InaSAFE.
Suggestion:
Expected Behaviour
QGIS should not be stalled by these output layers.
Environment
Checklist:
Proposed Solution
The text was updated successfully, but these errors were encountered: