You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
--------- Instructions --------
Please provide answers directly below each section.
--------- Instructions ---------
ESPixelStick Firmware Version
4.0-ci8301555430
Hardware Version
d1_mini_pro and d1_mini
Binary release or compiled yourself?
Mar 15 2024 - 19:48:24
Operating System (and version)
w10n 64
Web Browser (and version)
FF
Access Point
Describe the bug
Hi Manuel, I'm doing some tests with wemos d1 mini and wemos d1 mini pro (external antenna).
By setting out gpio 16 on d1 mini at high level (for a led on -> enable output relay> enable GPIO 16 >sigend Inverter> threshold 255 >> have the led on), the setting upon reboot, while on wemos d1 pro, when I set the output the led was on, but on reboot ,even if the panel appears correct, the output level is at low level (led off).
Simply I need to set a gpio (d0 or d1 or d2) to a high value as MONITOR to understand that the interface is on and working. Maybe I'm doing something wrong?
thank's in adavance
Mario
The text was updated successfully, but these errors were encountered:
iz1kbp
changed the title
GPIO problems with wemos D1 mini and Pro
GPIO problems with wemos D1 mini Pro
Apr 19, 2024
... basically. I use the same settings on WEMOS d1 mini and Pro. upon reboot, while the MINI maintains the GPIO outputs as programmed (ON), the PRO does not maintain them (OFF)
--------- Instructions --------
Please provide answers directly below each section.
--------- Instructions ---------
ESPixelStick Firmware Version
4.0-ci8301555430
Hardware Version
d1_mini_pro and d1_mini
Binary release or compiled yourself?
Mar 15 2024 - 19:48:24
Operating System (and version)
w10n 64
Web Browser (and version)
FF
Access Point
Describe the bug
Hi Manuel, I'm doing some tests with wemos d1 mini and wemos d1 mini pro (external antenna).
By setting out gpio 16 on d1 mini at high level (for a led on -> enable output relay> enable GPIO 16 >sigend Inverter> threshold 255 >> have the led on), the setting upon reboot, while on wemos d1 pro, when I set the output the led was on, but on reboot ,even if the panel appears correct, the output level is at low level (led off).
Simply I need to set a gpio (d0 or d1 or d2) to a high value as MONITOR to understand that the interface is on and working. Maybe I'm doing something wrong?
thank's in adavance
Mario
The text was updated successfully, but these errors were encountered: