3D-printed case for FabGL ESP32 board (3.3v)?

[vitasam]

Hello,
I received the FabGL board today, the firmware upload was successful - PC Emulator works out of the box (however, the pull request is required). Great board!

I have a question: Is there a 3D model for enclosure (case) for this board?

[johngalt01]

i couldn't find any.

there are a few versions for the VGA32 V1.1-1.4. it wouldn't be to hard to design a case just to enclose it but everyone has different needs and different configurations with things plugged into the i/o pins.

[vitasam]

I see. I have quite nice 3D model for TTGO VGA32 V1.4, from Thingverse. There is also quite interesting case available.

Maybe I will start to learn FreeCAD again.

[johngalt01]

i'm using this one https://www.thingiverse.com/thing:4790919
it has room for a 232 9 pin converter makes for a compact terminal or pc emulator.

[vitasam]

Yes, I saw this case on Thingverse site. As far as I understand, it is more suitable for Serial Terminal board rather than for development board.