You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
So i built the example with a single transistor as a amplifier and it uses the TX pin connected to the base to control the frequencies. for my project it would be important to use some other pin as the output source. is there any way to do this?
The text was updated successfully, but these errors were encountered:
On the ESP8266, the I2S data pin is hard wired to the same GPIO as TX. Just like the pins for SPI1, SPI2 and I2C are hardwired too. The I2S data pin is required for the ΔΣ-DAC in the "NoDAC" output generator. You can't switch the output pin for other I2S-based outputs (DAC or SPDIFF) either.
So i built the example with a single transistor as a amplifier and it uses the TX pin connected to the base to control the frequencies. for my project it would be important to use some other pin as the output source. is there any way to do this?
The text was updated successfully, but these errors were encountered: