You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When setting non default values for denoms_goal and denoms_hardcap in GUI, dash-qt still uses default values.
Steps to reproduce:
1.) Fresh installation of dashcore-20.1.1-x86_64-linux-gnu.tar.gz (no configuration files)
2.) Start dash-qt
3.) Set "Inputs per denomination" to Target = 10, Maximum = 16
4.) Check used values in console with getcoinjoininfo: 10/16, this is ok.
5.) Restart dash-qt
6.) Check values in GUI: 10/16, this is ok
7.) Check used values in console with getcoinjoininfo: 50/300, this is NOT ok.
Workaround: Set values in ~/.dashcore/dash.conf.
Cheers, Peter
The text was updated successfully, but these errors were encountered:
Hi,
When setting non default values for denoms_goal and denoms_hardcap in GUI, dash-qt still uses default values.
Steps to reproduce:
1.) Fresh installation of dashcore-20.1.1-x86_64-linux-gnu.tar.gz (no configuration files)
2.) Start dash-qt
3.) Set "Inputs per denomination" to Target = 10, Maximum = 16
4.) Check used values in console with getcoinjoininfo: 10/16, this is ok.
5.) Restart dash-qt
6.) Check values in GUI: 10/16, this is ok
7.) Check used values in console with getcoinjoininfo: 50/300, this is NOT ok.
Workaround: Set values in ~/.dashcore/dash.conf.
Cheers, Peter
The text was updated successfully, but these errors were encountered: