New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Connection to Com port #851
Comments
Hi James, I hope it would work fine. If not try using the client version of cncjs. Regards, |
Have you tried without rts/cts flow control? |
Also, do you have the CP210x USB-Serial driver installed on your laptop? |
Ta Titik
I have tried closing other ports – No luck there
Unplugged and reconnected multiple times
Restarted Both CNC and computer multiple times.
I have had suggestion that the CPX210 driver may be the issue, so trying that now
Thanks
James Gibson
Director
0427 290 323
aquawest.com.au<http://www.aquawest.com.au/>
***@***.***
From: Ipsum Coder ***@***.***>
Sent: Sunday, January 14, 2024 4:05 PM
To: cncjs/cncjs ***@***.***>
Cc: James Gibson ***@***.***>; Author ***@***.***>
Subject: Re: [cncjs/cncjs] Connection to Com port (Issue #851)
Hi James,
It seems you are using a port that is not being detected by the CNCjs Software. I highly recommend you to try the following steps:
i) Close all the other softwares which are using the ports or have access to ports
ii) Replug the cnc
iii) Check if the usb cable is properly shielded
iv) Restart The Program
I hope it would work fine. If not try using the client version of cncjs.
Regards,
Ritik AKA Ipsum Coder
—
Reply to this email directly, view it on GitHub<#851 (comment)>, or unsubscribe<https://github.com/notifications/unsubscribe-auth/A7GJAHQJPOEH3JM2BNCGDMLYONRRRAVCNFSM6AAAAABBRKISNCVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMYTQOJQHA2DSMJXGE>.
You are receiving this because you authored the thread.Message ID: ***@***.******@***.***>>
|
Can not connect to Com 3 port in CNCjs version 1.10.3
In the drop down Port menu there is never an option to connect - see below greyed out
I Can connect via the CNC_xPRO_V5(AP mode) and make the CNC work on all 3 x axis - see below
I am connected from the CNC xPRO via USB cable
Versions
How Do You Install CNCjs?
CNC Controller
Hardware
Running on new Laptop
Operating System
What am I doing wrong
James
The text was updated successfully, but these errors were encountered: