Marlin - Feedhold / Cyclestart -events do not seem to trigger

[ammoniak]

Description

I activated (in the Marlin Firmware) the "Emergency Parser" and the "Real time reporting commands" which enable the commands "R000", "P000" and "S000" to Pause (P000), Resume (R000) and Report State (S000) during an operation.
If you send a R000/P000 they skip the command buffer and execute immediately. That would be perfect for Feedhold/Cycle start.

I tried adding them in an event, but the event does not seem to trigger.
The documentation section about "Events" is empty.
I'm not sure if I'm doing something wrong (I just added a new event for Feedhold/Cyclestart, set it to "gcode" and added "P000" / "R000" into the text box and saved it.
The events are there and enabled, but they don't seem to do anything. I think they don't even get triggered, but I'm not sure.

If I enter the P000/R000 commands directly into the gcode-terminal, they work fine.

I assumed the events are able to actually inject gcode while gcode is running...

An option to configure Feedhold/Cyclestart would be another option, but the events would be enough for me (if they worked properly).

Am I missing something?

Btw. I volunteer to update the documentation for the events.

Versions

• CNCjs: 1.10.3

How Do You Install CNCjs?

• NPM
• Download the CNCjs Desktop Application

CNC Controller

• Grbl
• Smoothieware
• TinyG/g2core
• Marlin

Hardware

• Raspberry Pi
• Desktop or Laptop
• Mobile Device

Operating System

• Not Applicable
• Windows
• Mac
• Linux