You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello.
I have 3 FC Mamaba MK4 F722 MINI, WING and G4 Alpha.
Does not work OSD on Avatar Googles with INAV7 (6, 6.1) and FETTEC.
With BTFL OSD works.
I think The problem is in different the firmware BTFL and INAV for my flight controllers.
In FC firmware BTFL pin VTX FC is the same as pin RX3 FC, but in the firmware INAV pin VTX and pin RX3 are different.
I soldered one wire to RX3 FC and the osd INAV started working.
Do you know which command are doing it in the CLI line INAV?
I’am afraid I can’t solder the wires on other units (I haven't pin connector).
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Hello.
I have 3 FC Mamaba MK4 F722 MINI, WING and G4 Alpha.
Does not work OSD on Avatar Googles with INAV7 (6, 6.1) and FETTEC.
With BTFL OSD works.
I think The problem is in different the firmware BTFL and INAV for my flight controllers.
In FC firmware BTFL pin VTX FC is the same as pin RX3 FC, but in the firmware INAV pin VTX and pin RX3 are different.
I soldered one wire to RX3 FC and the osd INAV started working.
Do you know which command are doing it in the CLI line INAV?
I’am afraid I can’t solder the wires on other units (I haven't pin connector).
Than you.
Beta Was this translation helpful? Give feedback.
All reactions