Controlling drone with msp over USB #13431
Unanswered
richard-fpv
asked this question in
Q&A
Replies: 1 comment 1 reply
-
Bad idea doing this directly as the USB is far from deterministic and will really mess up timing. What you can do however is to use an FTDI adaptor connected to a UART, and set that to use MSP. |
Beta Was this translation helpful? Give feedback.
1 reply
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Hello,
I want to control my drone directly from a laptop through the USB connection (if possible).
In betaflight configurator, I can setup everything, so that in the receiver tab, under control sticks, I can control all the inputs including arming, mode change and motors. But the interface is not setup for flying, since I have to use the mouse to change throttle/jaw/pitch/roll.
Is there a way to map these to the inputs from a USB controller? Or another program that I could use for this purpose?
This is meant for a tethered drone project.
I am using an old QQ190 drone with a Teenycube Ominbus F3 FC and Betaflight version 3.2.0.
Best Regards
Richard
Beta Was this translation helpful? Give feedback.
All reactions