Need Betaflight Pros--Two motors work in cleanflight but not in betaflight

[DethRattles]

I have a hyperion vengeance drone with a naze32 running cleanflight 1.11.0 ....I was able to flash beta 4.06 since thats the highest firmware that supports the naze. The sliders in the motor tab dont correspond to the motors in the picture. Motors sliders 3 and 4 work but turn motors 1 and 2 on. The 1 & 2 sliders do nothing. I've tried to resource the motors doing the following:
resource Motor 1 none
resource Motor 2 none
resource Motor 3 none
resource Motor 4 none
resource Motor 5 none
resource Motor 6 none
resource Motor 1 B06
resource Motor 2 B07
resource Motor 3 B08
resource Motor 4 B09

but betaflight and the motors acted the same. I know that if servo_tilt is turned off in cleanflight then 2 motors wont spin. I made sure it was enabled on betaflight 2.5.6 i also tried 2.1 but not change. I tried with putting esc's on pwm too. The quad beeps as it should when plugged in,,just 3&4 motors do nothing. This is either something programmed into their propriety board or its betaflight . I really like how much betaflight improved my other drone and was hoping to do the same with this hyperion. Someone had the same issue https://discord.com/channels/868013470023548938/1181768489581690950/1181768489581690950 but he didnt say if it was because of cleanflight or maybe he had servo_tilt turned off and that fixed his issue. This drone originally come with a gimbal camera but my later released version did'nt(not sure if that has anything to do with it)
syncro on no two motors.txt
added the dump.

Thanks to anyone that responds!