You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi,
I am using snapcast with docker and mplayer. I have configured multiple sources to access internet radio streams. Snapcast is starting a mplayer-process for each stream. Everything starts to stream when snapcast is started. Is it possible to start each process only, if it is accessed? Otherwise it can be in idle state.
Previously I've tried process-source with mpv. But it was interrupted by daily DSL-reconnect and I needed to restart docker each time. I also tried mpd with pre-defined playlists. But this was a bit unhandy as well.
I want to pre-configure multiple radio streams and I don't want that all of them are causing traffic without being in use.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Hi,
I am using snapcast with docker and mplayer. I have configured multiple sources to access internet radio streams. Snapcast is starting a mplayer-process for each stream. Everything starts to stream when snapcast is started. Is it possible to start each process only, if it is accessed? Otherwise it can be in idle state.
Previously I've tried process-source with mpv. But it was interrupted by daily DSL-reconnect and I needed to restart docker each time. I also tried mpd with pre-defined playlists. But this was a bit unhandy as well.
I want to pre-configure multiple radio streams and I don't want that all of them are causing traffic without being in use.
Beta Was this translation helpful? Give feedback.
All reactions