You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
A clear and concise description of what the problem is.
I just bought some Deltaco CCT light bulbs, specifically the SH-LE14W and the SH-LE27W. Both have templates available on templates.blakadder.com.
I flashed one of the E14 bulbs with tuya-convert, updated it to the latest firmware and applied the correct template:
The problem is that instead of creating a bulb with two sliders (one for colour temperature and one for the dimmer), it creates one with four sliders:
The two sliders that I expected control the bulb correctly - the dimmer slider varies the light intensity and the colour temperature slider adjusts the colour temperature from cold to warm. There are only two PWM channels specified, so according to the documentation, that should create a two channel device, not a four channel one.
I tried using other templates and changing the module, but none of my alternative configurations control the bulb correctly.
REQUESTED INFORMATION
Make sure your have performed every step and checked the applicable boxes before submitting your issue. Thank you!
PROBLEM DESCRIPTION
A clear and concise description of what the problem is.
I just bought some Deltaco CCT light bulbs, specifically the SH-LE14W and the SH-LE27W. Both have templates available on templates.blakadder.com.
I flashed one of the E14 bulbs with tuya-convert, updated it to the latest firmware and applied the correct template:
{"NAME":"SH-LE14W","GPIO":[0,0,0,0,0,140,0,0,38,0,37,142,141],"FLAG":0,"BASE":18}
The problem is that instead of creating a bulb with two sliders (one for colour temperature and one for the dimmer), it creates one with four sliders:
The two sliders that I expected control the bulb correctly - the dimmer slider varies the light intensity and the colour temperature slider adjusts the colour temperature from cold to warm. There are only two PWM channels specified, so according to the documentation, that should create a two channel device, not a four channel one.
I tried using other templates and changing the module, but none of my alternative configurations control the bulb correctly.
REQUESTED INFORMATION
Make sure your have performed every step and checked the applicable boxes before submitting your issue. Thank you!
Backlog Template; Module; GPIO 255
:Backlog Rule1; Rule2; Rule3
:Status 0
:(Please use
weblog 4
for more debug information)TO REPRODUCE
Steps to reproduce the behavior:
Apply template.
EXPECTED BEHAVIOUR
A clear and concise description of what you expected to happen.
A light with only the applicable controls should be created.
SCREENSHOTS
If applicable, add screenshots to help explain your problem.
ADDITIONAL CONTEXT
Add any other context about the problem here.
(Please, remember to close the issue when the problem has been addressed)
The text was updated successfully, but these errors were encountered: