Support Nextion 3.5 inch

[jvle]

Can I use the existing nexton-lcd.HMI, change device to 3.5 nextion display, the move and resize some buttons around (without changing nay opcode sent to Arduino? Would that work without changing Arduino source code?

[Zer0-bit]

Should work if you know what you're doing.

[EngMarc]

I've ordered both the the smaller TFT and the 3.5 TFT. I'm planning to scale up and significantly modify the UI so wanted to try both sizes.

[McTecnic]

If in the nextion LCD Editor to the corresponding device, e.g. 3.5", at least the 2.4" surface in the upper left corner of the 3.5" LCD runs in the debugger.
After adjusting the position of the buttons and graphics, the simulation also works.

[EngMarc]

Great, nice to know and thanks.

[kohlwebb]

How did this go? Were you able to successfully size up the interface?