AMT only working when device is powered on? #6054
Replies: 4 comments 3 replies
-
Are u sure u have connected the computer to the amt correctly? Also if u have multiple computers on the same network and in the same group in meshcentral, so long as your device has wake on lan setup/activated, then meshcentral will tell other devices that are online, hey wake up this computer plz with wol packets! |
Beta Was this translation helpful? Give feedback.
-
Well, on the general tab for this particular machine, it says that it has recognized Intel AMT. And under the Intel AMT tab on this page, it shows a lot of AMT info that I can't see when I access AMT via the browser. So, yes, I'd say this connection is via AMT. |
Beta Was this translation helpful? Give feedback.
-
of course: |
Beta Was this translation helpful? Give feedback.
-
MC is running in a local VM but on a different network from the AMT port of the machine. This is more by coincidence than purpose (because the network interfaces of the machine kept switching names). I could probably put the machine's AMT port on the same network as MC, if that helps. Intel AMT is set to "No Policy" |
Beta Was this translation helpful? Give feedback.
-
Hi,
I have had MeshCentral set up and running for a few weeks and I'm loving it.
Recently, I connected my first (and only) AMT device (Lenovo Thinkstation).
My issue is that MeshCentral only seems to see it, when the device is already on. But after it is shut down, MC reports that it was disconnected. Now, my primary reason for connecting the PC to MC is to be able to power it on remotely. And this is the only thing that doesn't seem to work...
I can reach AMT in my browser at any time. But MC can connect only, when the device is switched on.
Is this a misconfiguration on my part or is this expected behaviour?
Thanks!
Beta Was this translation helpful? Give feedback.
All reactions