Rapido 2 Toolhead: Orientation in README.md not correct.

[Laikulo]

The supported orientation in the markdown file at STLs/Stealthburner/Printheads/phaetus_rapido_v2/README.md indicates that the grub screw should be at 4:30, and the wires at 12:00, with the screwhole nearest the wires at 12:30, however this orientation does not align the screwholes.

I found that the wires at 12:00, screw at 7:30 with the hole nearest the wires at 11:30 when viewed from the top (the face with the four holes as indicated.

[Laikulo]

This is actually going to be user error. I misinterpreted the note about the orientation being different for the v2, and was unsure what figure to use. I just wound up testing all three orientations

[Laikulo]

Actually, aligning the grub screw with the wires (as pictured) is not the correct alignment. The correct alighment is the one not pictured in either diagram...

[michmerr]

I just went through this.

I think the "supported" alignment is correct, with the wires at 12 o'clock and the grub screw at 4 o'clock. However, the very next paragraph in the readme.md describes an alignment image with the caption, "Be sure that the heatbrake set screw, thermistor wires, and heater wires are all aligned as shown below:" As described, that image shows the grub screw aligned with the wires, which is not correct. It looks like all subsequent illustrations have the grub screw in the stock in-line position rather than the supported alignment that is only pictured once.

@kyleisah