You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
SP6000 Panel, IP150+ Internet Module & ZX8 Expansion Module
Environment
Running the latest HA update 2023.05 on a Intel NUC
Question
My SP6000 has 8 Zones and then I have the ZX8 Expansion Module(
which provides a further 8 Zones and 1 PGM. PAI detects the SP6000 8 zones and 4 pgm's however not the ZX8 modules 8 zones and 1 pgm.
Is it possible to get the integration to see these as well perhaps ?
The text was updated successfully, but these errors were encountered:
When you log into babyware, can you see all the zones?
Can you also check what your "limits" configuration is set to at present?
Have you taken a look at what topics show up, when you browse the MQTT broker, under the "paradox" section?
I have the same setup, and for me at least, I am able to see all 16 zones.
I have attached what my limits configuration looks like, if it can be of any assistance.
zone: auto
user: 1-3
door: ""
pgm: 1-5
partition: auto
module: ""
repeater: ""
keypad: ""
key-switch: ""
Alarm system
SP6000 Panel, IP150+ Internet Module & ZX8 Expansion Module
Environment
Running the latest HA update 2023.05 on a Intel NUC
Question
My SP6000 has 8 Zones and then I have the ZX8 Expansion Module(
which provides a further 8 Zones and 1 PGM. PAI detects the SP6000 8 zones and 4 pgm's however not the ZX8 modules 8 zones and 1 pgm.
Is it possible to get the integration to see these as well perhaps ?
The text was updated successfully, but these errors were encountered: