You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I replaced the firmware on a Wyze v3 camera (model WYZEC3B, SOC Ingenic T31X, 16MB NOR) using the official installation guide, but I cannot complete the process as the bootloader is missing setnor16m and many other values.
The bootloader environment looks like this. I have another camera, same model, that I flashed several months ago. That one works perfectly and the environment looks very different, containing e.g. the setnor16m that I am missing. I always used the newest prebuilt firmware from the website and I don't have the image that I had flashed on the earlier camera to play around with anymore unfortunately.
I tried copying over the entire environment from my working camera, ran saveenv and then run setnor16m. I got no errors, but the bootloader is still not finding the partitions it needs, see the attached boot log. I know I am running the OpenIPC bootloader, as the prompt is OpenIPC #. I also tried downloading and re-flashing just the bootloader, following the advanced section of the installation guide, but it made no difference.
The text was updated successfully, but these errors were encountered:
I replaced the firmware on a Wyze v3 camera (model WYZEC3B, SOC Ingenic T31X, 16MB NOR) using the official installation guide, but I cannot complete the process as the bootloader is missing
setnor16m
and many other values.The bootloader environment looks like this. I have another camera, same model, that I flashed several months ago. That one works perfectly and the environment looks very different, containing e.g. the
setnor16m
that I am missing. I always used the newest prebuilt firmware from the website and I don't have the image that I had flashed on the earlier camera to play around with anymore unfortunately.I tried copying over the entire environment from my working camera, ran
saveenv
and thenrun setnor16m
. I got no errors, but the bootloader is still not finding the partitions it needs, see the attached boot log. I know I am running the OpenIPC bootloader, as the prompt isOpenIPC #
. I also tried downloading and re-flashing just the bootloader, following the advanced section of the installation guide, but it made no difference.The text was updated successfully, but these errors were encountered: