"M109 S200" never finishes #44
Comments
|
Just curious - what was the issue? |
|
No solution yet. Extruder heats up slowly but doesn't seem to be getting the aimed temperature. It is hot but not hot enough to melt the PLA. |
|
After turning on debugging I can see the temperature stops around 180C at max 100% power. It slowly goes up, in 20 minutes it reaches 183C. |
|
I've seen extruders which work 12V and 24V. Are you sure that you power up your extruder with correct voltage? At 100% power it should burn in few dozens of seconds.... |
|
to check it with 100% confidence - connect heater directly to PSU - will it reach more than 180C? Be careful, good extruder shall reach 400-500C in 10-20 seconds and burn if you do not turn it off. |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
The command
M109 S200never finishes. However the hotend is hot. When I unplug the thermistor it crashes, next time won't even start until complete restart, saying ads1115 not detected. What's wrong? Thanks!The text was updated successfully, but these errors were encountered: