Welcome to myrobotlab Discussions!

[supertick]

👋 Welcome!

We’re using Discussions as a place to connect with other members of our community. We hope that you:

• Ask questions you’re wondering about.
• Share ideas.
• Engage with other community members.
• Welcome others and are open-minded. Remember that this is a community we
  build together 💪.

To get started, comment below with an introduction of yourself and tell us about what you do with this community.

[kwatters]

Hello, I am Kevin. I help maintain the MRL code base. I have built 2 InMoov robots.

[raspberrypi-devel]

wow very impressive Kevin. can you please just answer one question for me i have printed everything above the waist and have installed and successfully run myrobotlab on windows 10. i can connect to the arduino 2560 and the main nervoboard and applied power. i have connected the eyes board with servos attached i can get MRL to connect to the arduino but i cannot get the eyes to move and gael and cyberone has suggested i look in forums because many others have had this issue.
i am assuming to get the eyes to move to get the eyes.py code and insert/load it into the nervoboard/arduino ? do i load it right after i load mrlcomm.ino? if not when do i load it? THE ANSWER TO THIS WILL GET ME ON MY MERRY WAY.
THANX handfingerrobot

[supertick]

Ahoy ! .. I'm Greg/GroG, There's a Discord Server here , but GitHub had a shiny new "Discussions!" button, and I couldn't help but push it. I'm one of the monkeys that develop MRL code.

[raspberrypi-devel]

hi greg/grog thanx for all your help you have got me on my way!