Replies: 3 comments
-
That page suggests MIDI support was added in the latest firmware version of the Wavetrigger, just checking if that's your case before digging any further. Edit: My bad, it's just realtime controls and pitch bend that were in the latest firmware. Could this be a channel issue? Maybe try other channels than 1 and see what happens. |
Beta Was this translation helpful? Give feedback.
-
mh I don't know which firmware version is on the board but I assume it is 1.28 because (if I remember correctly) this was the latest stable version at the time I bought the board (and it still is). Up to version 1.30 track numbers are computed as
That track number then determines the first three 0-leading digits in the file name that is loaded to play the note. |
Beta Was this translation helpful? Give feedback.
-
I finally succeeded in triggering sound, but oddly I have to use channel 2 where I was expecting channel 0 to be appropriate: robertsonics/WAV-Trigger-Arduino-Serial-Library#26 |
Beta Was this translation helpful? Give feedback.
-
Hello everyone. I am struggling to play a note on the Wavetrigger board.
I have done the following:
I have been playing around with a few arduino sketches, like the one below, but none of them ever produced a sound.
Could anyone give me a hint on how to get this to work?
According to the manual on
sendNoteOn
I do have to pass in bytes, but I did also try to usebytes(note)
in the sketch below.(I am also asking in an issue over at the Wavetrigger repository: robertsonics/WAV-Trigger-Arduino-Serial-Library#25)
Beta Was this translation helpful? Give feedback.
All reactions