Mateksys r24 vario ELRS receiver channel 5 only 1 pin

[Capt-737NG]

Dear members, I want to use the channel 5 to control the landing gear (retract/extend) but there’s only one pin, while the LG servo has 3 pins (+ - S) which pin should I connect to the channel 5 on the receiver?

[mha1]

If you have a spare PWM connector use that an drive the landing gear with the respective mixer channel.

It now: your receiver should have a single pin marked 8. Use that to connect to the landing gear servo signal pin. Get + and - from one of the reveivers servo connector. The landing gear should now be controllable by EdgeTX mixer 8.

[Capt-737NG]

Thanks a lot Michael, I’ll do that! Cheers Cristiano

…

On Wed, 27 Mar 2024 at 06:40 Michael ***@***.***> wrote: If you have a spare PWM connector use that an drive the landing gear with the respective mixer channel. It now: your receiver should have a single pin marked 8. Use that to connect to the landing gear servo signal pin. Get + and - from one of the reveivers servo connector. The landing gear should now be controllable by EdgeTX mixer 8. — Reply to this email directly, view it on GitHub <#2603 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ATTDTRZE2XL63CWDIMFQ72LY2IPQXAVCNFSM6AAAAABEZ6JV6OVHI2DSMVQWIX3LMV43SRDJONRXK43TNFXW4Q3PNVWWK3TUHM4DSMRSGU4TQ> . You are receiving this because you authored the thread.Message ID: ***@***.***>