After installing the program and running, you should have access to the main program window:
The program opens on the feed tab by default. In the tab there are most relevant torrents that are collected, with which some actions have been performed recently (recent likes, comments, etc.). If the tab is empty, you just need to wait for it to sync with any of the available peers (see below).
After the start, initially you do not have a search database. You can use ready-made search when copy datatabase into the settings folder, or wait until you have accumulated your database to a sufficient size, which will automatically happen if the settings are correct. Or simply use distributed search.
Collection of new torrents from the network should start automatically, in a minute or two after the program is launched (in case of correctly opened ports). This can be monitored in the field with torrents under the search, as well as in the list of torrents in the activity tab.
The speed of the collection of torrents will increase with time. For details on configuring the scanner, refer to the torrent scanner configuration.
In the case when the collection of torrents does not occur, or is very slow (1-2 torrents in a few minutes), make sure that the ports specified in the settings are opened. Check next paragraph.
For correct operation, it is necessary that ports 4445 and 4446 (or others specified in the settings) are opened. Both types of ports (UDP and TCP) must be opened. On the router, the ports must necessarily be thrown through NAT (if enabled). In the case when router supports UPnP ports will be forwarded automatically.
Over time, your database of torrents will naturally grow up, and you can search for the torrent you are interested in using the search.
In the case of the other ROTB clients found, there will be indicator at the top
You will be able to search advanced search among other ROTB clients, you need to perform a normal search, but additional results will be displayed. Depending on the number of peers and exactly those who found the result of the extended issue may vary.
The results of search of other participants are marked with a separate color.
In the settings there are 3 parameters responsible for configuring the search for torrents in the network, each of them affects the application load, the rate of collection of torrents, the generation of traffic, as well as the total load for equipping the intermediate nodes of the network (router, etc.)
Recommended values:
- Maximum fast search / high load:
- Scanner walk speed: 5
- Nodes usage: 0 (disabled = max usage)
- Reduce netowork packages: 0 (disabled = unlimited)
- Average search speed / average load:
- Scanner walk speed: 15
- Nodes usage: 100
- Reduce netowork packages: 600
- Low search speed / average load:
- Scanner walk speed: 30
- Nodes usage: 10
- Reduce netowork packages: 450
In some cases, you may not be interested in torrents of a certain type, size or language, and you want the scanner to ignore them, and your database does not save them. To do this, use settings area for the settings of torrent filter
To do this, select the appropriate settings and save them. After that, depending on the need, you can check and clean the database in accordance with the new settings.