You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have built a hollow hemisphere with a small cylinder-shaped cut as shown in the figure, but when I export it as step or stl, I do not see the small cut! Can you help me on that?
and here is the saved object
The text was updated successfully, but these errors were encountered:
I have figured out the issue. The problem arose from attempting to use dimensions smaller than the base unit of CadQuery's system, which is millimeters. Therefore, dimensions such as 0.001 were being ignored.
It's essential to note that CadQuery's unit system is based on millimeters. Hence, there's no need for fractions like 0.001, as they will be disregarded when exporting to step.
I have built a hollow hemisphere with a small cylinder-shaped cut as shown in the figure, but when I export it as step or stl, I do not see the small cut! Can you help me on that?
and here is the saved object
The text was updated successfully, but these errors were encountered: