You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
While cutting sometimes the AB Motors skip because of the high pressure applied on the lever.
Using nema 17 with 1A currently.
Did somebody noticed the same behaviour?
The text was updated successfully, but these errors were encountered:
seacred
changed the title
Issue with lost steps because of too much pressure while pressing the lever
Issue with motors skipping because of too much pressure while pressing the lever
Dec 4, 2023
seacred
changed the title
Issue with motors skipping because of too much pressure while pressing the lever
Issue with motors skipping because of too much pressure applied on the lever
Dec 4, 2023
I wasn't able to solve this issue by now. i tried to reduce the cuttingmovespeed to a minimum but ist working for some cuts and suddenly it will skip. not reliable cutting over some swaps and longer prints possible by now.
While cutting sometimes the AB Motors skip because of the high pressure applied on the lever.
Using nema 17 with 1A currently.
Did somebody noticed the same behaviour?
The text was updated successfully, but these errors were encountered: