You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Just today I installed a new version of the firmware: v1.46. It looks like the device now uses a new PIN with 6 digits instead of four and the pairing process has been implemented properly. At least I actually had to enter the code when pairing with a RaspberryPi, while devices with v1.20 paired without a code.
Will proper pairing be implemented or do we have to avoid updating the firmware on our devices?
The text was updated successfully, but these errors were encountered:
I've upgraded one of my EQ-3s to 1.46 today and it still seems to communicate fine with this application. I can confirm that when using calorBT on an android phone I need to use the 6-digit pairing code with this device.
Can you check that your device still works too? If so I guess we can assume that this application will continue to work with this firmware.
To be honest I haven't even started working with your project, yet. I just stumbled upon this repository and didn't find any info about pairing, or that pairing is not required. So I was just wondering if this is still true.
I did some tests on a RPi with bluetoothctl and was actually forced to enter a code for the single upgraded thermostat, whereas the outdated ones could still pair without any interaction/PIN.
If I understand you correctly, you tested with an already paired device, right? In my case there's nothing set up, yet. Since I have a working solution already, I'm not sure when I can spare the time to test it. If you are ok with keeping this issue open for a while, I'll report back as soon as I find the time.
Just today I installed a new version of the firmware: v1.46. It looks like the device now uses a new PIN with 6 digits instead of four and the pairing process has been implemented properly. At least I actually had to enter the code when pairing with a RaspberryPi, while devices with v1.20 paired without a code.
Will proper pairing be implemented or do we have to avoid updating the firmware on our devices?
The text was updated successfully, but these errors were encountered: