You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Whenever the keepon boots with its normal firmware, it rotates itself until the pins on the circuit board line up with the bottom metal plate, to center the motors. When we ground out the bus, this doesn't happen. See what the master node sends on boot to know if there's a way we can trigger this calibration.
The text was updated successfully, but these errors were encountered:
Whenever the keepon boots with its normal firmware, it rotates itself until the pins on the circuit board line up with the bottom metal plate, to center the motors. When we ground out the bus, this doesn't happen. See what the master node sends on boot to know if there's a way we can trigger this calibration.
The text was updated successfully, but these errors were encountered: