[Question] Verification fails at 69% #376
-
|
I uploaded this firmware properly to my printer a few times before but when I tried to update it now it just gets stuck at verification at 69% |
Beta Was this translation helpful? Give feedback.
Replies: 4 comments
-
|
I uploaded successfully a few times previously today, I didn't change anything with my setup between flashes. USB communication is good. |
Beta Was this translation helpful? Give feedback.
-
|
cable close to light / or any power supply may disturb, also be sure upload speed is not too fast etc.. |
Beta Was this translation helpful? Give feedback.
-
|
I has same problem using any version other than 1.5.8 (arduino ide) |
Beta Was this translation helpful? Give feedback.
#185